KEPCO KLN Series (750W, 1500W, 3000W), Main Contro Firmware Version 1.70 and higher - Manual (Page 64)

3-18
KLN Series 051614
3.3.24 SET/VIEW 4TH PART OF IP ADDRESS (LAN INTERFACE ONLY)
Used to set (if DHCP function is OFF) or view (if DHCP is ON) part 4 (nnn) of the 4-part IP
address (xxx.xxx.xxx.nnn) where nnn can be set from 0 to 254. Refer to PAR. 3.3.19 to set
DHCP on/off. When setting the IP address, verify that all four parts of the address are set cor-
rectly (see PARs. 3.3.21 through 3.3.23).
1. Enter the menu (see PAR. 3.2.2 and Table 3-3) and rotate the encoder until Voltage display
shows (S.IP4) if DHCP is OFF or (V.IP4) if DHCP is ON to
access part 4 of IP address.
2. Press ENTER key to view setting.
For example, (100) displayed in Current display for IP Address xxx.xxx.xxx.100.
3. If Voltage display shows (S.IP4), set by rotating encoder until Current display
shows desired setting (tap encoder to adjust 10’s or 100’s digit more rapidly). Press ENTER
to confirm.
3.3.25 SET/VIEW 1ST PART OF SUBNET MASK ADDRESS (LAN INTERFACE ONLY)
Used to set (DHCP function is OFF) or view (DHCP is ON) part 1 (nnn) of the 4-part Subnet
Mask address (nnn.xxx.xxx.xxx) where nnn is a number from 0 to 255. The default subnet mask
address is 255.255.255.0. Refer to PAR. 3.3.19 to set DHCP on/off. When setting the subnet
mask, verify that all four parts of the address are set correctly (see PARs. 3.3.26 through
3.3.28). Figure 3-5 shows the commands used to set/view addresses depending on whether
DHCP and DNS functions are on or off.
1. Enter the menu (see PAR. 3.2.2 and Table 3-3) and rotate the encoder until Voltage display
shows (S.MN1) if DHCP is OFF or (V.MN1) if DHCP is ON.
2. Press ENTER key to view setting.
For example, (255) displayed in Current display for subnet mask address
255.xxx.xxx.xxx.
3. If Voltage display shows (S.MN1), set by rotating encoder until Current display
shows desired setting (tap encoder to adjust 10’s or 100’s digit more rapidly). Press ENTER
to confirm.