KEPCO KLN Series (750W, 1500W, 3000W), Main Contro Firmware Version 1.70 and higher - Manual (Page 23)

KLN Series 051614 1-13
1.7.5 MISCELLANEOUS FEATURES
• Both positive and negative output ramps can be independently programmed (see PAR’s.
3.3.10 and 3.3.11).
• Last setting is automatically restored upon power-up. Output can be programmed to be
either on or off upon power-up (see PAR’s. 3.3.9).
• One key recall of up to 16 memory locations storing voltage and current settings (see
PAR’s. 3.3.39 and 3.3.7).
• Variable speed fans reduce noise and extends fan life.
• Non-gap stacking; No ventilation holes at top or bottom.
• CE Mark approved.
• Approved as compliant to LXI Version 1.4, Device Specification 2011.
1.8 EQUIPMENT SUPPLIED
Equipment supplied with the KLN power supply is listed in Table 1-3.
TABLE 1-3. EQUIPMENT SUPPLIED
ITEM DESCRIPTION
KEPCO PART
NUMBER
Power Cable, (125V/15A) (750W only) Connects unit to 115V a-c source power. 118-0557
Power Cable (1500W, 3000W only) Connects unit to 230V a-c source power. 518-0120
Sense wires: Red (6V - 100V models) Used to connect output to local sensing
connections: red: (+) to +S, black: (–) to –S 118-1302
Sense wires: Red (150V - 600V models) Used to connect output to local sensing
connections: red: (+) to +S, black: (–) to –S 118-1304
Sense wires: Black (6V - 100V models) Used to connect output to local sensing
connections: red: (+) to +S, black: (–) to –S 118-1303
Sense wires: Black (150V - 600V models) Used to connect output to local sensing
connections: red: (+) to +S, black: (–) to –S 118-1305
Mating connectors (RS-485 and Sense) One supplied installed on RS-485 port to
allow access to RS 485 interface; one
supplied installed on Sense connector to
provide access to sense connections used
to compensate for voltage drop on load
connections 542-0037
Programming Control Port cover Supplied installed on Programming Control
port to protect programming port pins. 137-0155