KEPCO KLN Series (750W, 1500W, 3000W), Main Contro Firmware Version 1.70 and higher - Manual (Page 14)

1-4 KLN Series 051614
OUTPUT CHARACTERISTICS
Type of Stabilizer Constant Voltage (CV)/Constant Current (CC),
automatic crossover
Adjustment Range Voltage:
Current: 0 to 100% of rated voltage
0 to 100% of rated current
Protective functions Programmable overvoltage (OVP),
Programmable overcurrent (OCP),
Overtemperature (OTP),
Fuse blown
Protection setting range Overvoltage:
Overcurrent:
0% to 110% of rated voltage
0% to 110% of rated current
Remote Error Sense Compensation 5V max. (See Table 1-1.)
Parallel Operation Up to 5 units maximum, automatic load sharing
Current sharing tolerance: 1% at rated current, 5% at 50% of rated current, 10% at
less than 10% of rated current
Series Operation 2 units maximum (total voltage must not exceed 600V)
Temperature Coefficient Constant Voltage Mode,
Constant Current Mode: 100ppm/°C of rated output voltage or current, after 30 min-
ute warm-up
Time (Drift) Constant Voltage Mode,
Constant Current Mode: 0.05% of rated output voltage or current over 8hrs interval
following 30 minutes warm-up. Constant line, load and tem-
perature.
Transient response time Constant Voltage mode: 20V and under:

1.5ms;
30V~100V:

1ms
150V~600V:

2ms
Hold-up time 20ms
Efficiency 750W:
1500W:
3000W:
76% – 87%
77% – 88%
82% – 88%
Isolation Voltage Input - Outputs:
Input - Ground:
Output - Ground (6V-150V)
Output - Ground (300V-600V)
2000V a-c: 1 minute
2000V a-c: 1 minute
350V d-c, leakage current: 100

A
1200V d-c, leakage current: 100

A
PROGRAMMING CHARACTERISTICS - LOCAL
Display resolution Voltage and Current: 4 digits (setting and display)
Display setting accuracy Voltage:
Current: ±0.1% ± 3C
(2)
at rated voltage
±0.5% ± 3C
(2)
at rated current
Display reading accuracy Voltage:
Current: ±0.2% ± 3C
(2)
at rated voltage
±0.5% ± 3C
(2)
at rated current
(2) C = 1 count of the last displayed digit.
TABLE 1-2. KLN GENERAL SPECIFICATIONS (CONTINUED)
SPECIFICATION RATING/DESCRIPTION