KEPCO KLN Series (750W, 1500W, 3000W), Main Contro Firmware Version 1.70 and higher - Manual (Page 82)

3-36
KLN Series 051614
FIGURE 3-11. NETWORK CONFIGURATION PAGE
The four fields of the top section allow the user to set Host Name, Description and Domain as
well as enable or disable mDNS Discovery. Using mDNS allows the KLN to determine the IP
address of a given host (a host name) without the direct help of a centralised DNS server. Once
changes have been made, immediately below the top section click on Cancel to revert to the
previous settings, or Apply to apply the changes.
The lower section determines where the IP Address and DNS Server address comes from, and
can be used to manually change the Socket Port from 5025 (the default) if needed. Setting IP
Address From to DHCP-Auto allows the IP, Subnet Mask and Default Gateway addresses to
be found automatically. If IP Address From is set to Manual the user can enter the desired
addresses, Similarly, Setting DNS Server Address From to Auto or Manual allows Preferred
and Alternate DNS addresses to be found automatically or be assigned by the user. Once
changes have been made, immediately below the lower section click on Cancel to revert to the
previous settings, or Apply to apply the changes. Clicking on LAN Configuration Initialize will
restore the IP Configuration Settings to the factory default.