KEPCO KLN Series (750W, 1500W, 3000W), Main Contro Firmware Version 1.70 and higher - Manual (Page 83)

KLN Series 051614
3-37
3.6.3.3 CHANGING LAN PASSWORD
When operating the KLN via the LAN for the first time, click Security at the top left of the Wel-
come Page to bring up the Change Password screen (Figure 3-12). If desired, change the old
password from the default (admin) to one of your choosing. Ensure that New Password and
Confirm Password fields are identical. If the password is lost, it can be reset to “admin” by exe-
cuting the IP Address Reset (RST1) from the front panel (see PAR. 3.3.49). however this will
also reset other LAN settings to the default as well.
FIGURE 3-12. CHANGE PASSWORD SCREEN
3.6.3.4 INSTRUMENT CONTROL
The Instrument Control page (see Figure 3-13) contains the basic controls used to operate the
KLN power supply. To view the Instrument Control page, click on Instrument Control at the top
left of the Welcome page. You may be asked to Log In with a password before access to this
screen is granted. Voltage and current setpoints are displayed above the empty fields above the
Set V and Set I buttons, respectively. The output can be enabled by the OUTPUT ON/OFF but-
ton at the right. If the output is on, the ON indicator (at the lower left of the group of six indica-
tors) is on, and the voltage and current displayed appear at the output. To program
voltage/current, enter the setpoint value in the field above the corresponding SET button, then
click the SET button to apply the change. The CC, CV, OCP, OVP ON and Alarm indicators cor-
respond to the front panel indicators (see Figure 3-1 (750W), 3-2 (1500W), or 3-3 (3000W), and
Table 3-1. The RESET button corresponds to the front panel RESET button.
FIGURE 3-13. INSTRUMENT CONTROL PAGE