KEPCO KLN Series (750W, 1500W, 3000W), Main Contro Firmware Version 1.70 and higher - Manual (Page 70)

3-24
KLN Series 051614
3.3.41 CALIBRATION ACCESS
Allows access to calibration mode which is password protected.
1. Enter the menu (see PAR. 3.2.2 and Table 3-3) and rotate the encoder until Voltage display
shows (CAL) to access CALIBRATION mode.
2. Press ENTER key to access setting (password).
3. Rotate encoder until Current display shows desired setting for blinking digit.
4. Tap encoder to go to next digit and repeat step 3 for all digits of the password, then press
ENTER to confirm.
5. Refer to PAR. 4.1 to calibrate the unit.
3.3.42 VIEW SERIAL NUMBER
Allows viewing of 6-digit serial number.
1. Enter the menu (see PAR. 3.2.2 and Table 3-3) and rotate the encoder until Voltage display
shows (SN) in the two left-most characters.
2. Serial Number displayed starting with two right-most digits (10) in Voltage dis-
play and four digits in Current display (0000).
3.3.43 VIEW MAIN CONTROL VERSION
Allows viewing of main control firmware version
1. Enter the menu (see PAR. 3.2.2 and Table 3-3) and rotate the encoder until Voltage display
shows (FW). to view the unit main control version.
2. Main Control Version displayed as 1.00 (typical) in Current display.
3.3.44 VIEW HARDWARE VERSION
Allows viewing of hardware version
1. Enter the menu (see PAR. 3.2.2 and Table 3-3) and rotate the encoder until Voltage display
shows (HW). to view the unit hardware version.
2. Hardware Version displayed as 1.00 (typical) in Current display.
3.3.45 VIEW 1ST PART OF MAC ADDRESS (LAN INTERFACE ONLY)
Used to view first two hex numbers (aa.bb) of the 6-character MAC address (aa.bb.cc.dd.ee.ff)
where aa and bb are Hex numbers from 00 to FF. The default MAC address is
70.60.42.00.00.00.
1. Enter the menu (see PAR. 3.2.2 and Table 3-3) and rotate the encoder until Voltage display
shows (V.MA1).
2. Press ENTER key to view setting.
For example, (70.46) displayed in Current display for MAC address
70.46.42.00.00.00.