KEPCO KLN Series (750W, 1500W, 3000W), Main Contro Firmware Version 1.70 and higher - Manual (Page 47)

KLN Series 051614
3-1
SECTION 3 - OPERATION
3.1 GENERAL
This section explains how to operate the KLN Power Supply. KLN Power Supplies feature three
modes of operation:
• Local Mode (see PAR. 3.3): This is the default operating mode, providing full access to
all programming and readback functions via front panel displays, controls, and indica-
tors.
• Analog Remote Mode (see PAR. 3.5): The unit can be controlled using analog signals
applied via the Programming Control port, regardless of whether local or digital remote is
active.
• Digital Remote Mode (see PAR. 3.6): This mode is selected via commands transmitted
through one of the digital ports. One port is for RS-485 port [standard models] The sec-
ond port is optional: either an IEEE-488 (GPIB) (G-suffix models) port or a LAN port [E-
Suffix models]. The port to be used must first be enabled using the Menu (see I/O Select,
PAR. 3.3.15). The power supply automatically goes into digital remote mode when com-
mands are accepted via one of the digital ports. All communication is via SCPI com-
mands which afford full functionality of the KLN (see PAR. 3.7, Appendix A and Appendix
B).