KEPCO KLN Series (750W, 1500W, 3000W), Main Contro Firmware Version 1.70 and higher - Manual (Page 59)

KLN Series 051614
3-13
3.3.15 I/O SELECT
Used to select either RS-485 (standard) or optional GPIB or LAN interfaces for remote digital
control.
1. Enter the menu (see PAR. 3.2.2 and Table 3-3) and rotate the encoder until Voltage display
shows (I.O) to access I/O SELECT setting.
2. Press ENTER key to view setting.
RS-485 mode displayed as (485) in Current display.
GPIB mode displayed as (GPIB) in Current display if GPIB interface installed.
LAN mode displayed as (LAN) in Current display if LAN interface installed.
3. Rotate encoder until Current display shows desired setting, then press ENTER to confirm.
3.3.16 RS-485 BAUD RATE
Used to select baud rate for RS-485 communication. Default setting is 115K
1. Enter the menu (see PAR. 3.2.2 and Table 3-3) and rotate the encoder until Voltage display
shows (485) to access RS-485 BAUD RATE setting.
2. Press ENTER key to view setting.
4800 baud rate displayed as (4.8K) in Current display.
9600 baud rate displayed as (9.6K) in Current display.
19200 baud rate displayed as (19.2K) in Current display.
38400 baud rate displayed as (38.4K) in Current display.
57600 baud rate displayed as (57.6K) in Current display.
115200 baud rate displayed as (115K) in Current display.
3. Rotate encoder until Current display shows desired setting, then press ENTER to confirm.
3.3.17 GPIB ADDRESS (GPIB INTERFACE ONLY)
Used to set the GPIB address. Available addresses from 00 to 30. Default GPIB address is 07.
1. Enter the menu (see PAR. 3.2.2 and Table 3-3) and rotate the encoder until Voltage display
shows (GPIB) to access GPIB ADDRESS setting.
2. Press ENTER key to view setting.
GPIB address (default) displayed as (07) in Current display.
3. Rotate encoder until Current display shows desired setting, then press ENTER to confirm.