TA Triumph-Adler DC 2062 - Manual (Page 40)

Section 5 OTHER CONVENIENT FUNCTIONS
2A080030A
KM-6230 (KME)
/ 131
1. Set the originals.
POINT OF INFORMATION
When you set the originals be sure that their top (or left) side is set towards the rear of the DF
or the platen. If you do not set the originals in the proper direction, the margin may be created
in the wrong location.
2. Touch the “FUNCTION” key.
The function select screen will appear.
3. Touch the “MARGIN” key. (If that key is not displayed, touch the “ ▼ ” key or the “ ▲ ” key until
it is displayed.)
The margin copy set-up screen will appear.
If you want to select a left or top margin, go to the next step.
If you want to select both a front and back margin, go to step 6.
4. If you want to change the width of the margin, touch the “+” key or the “-” key until the
desired width is displayed.
The margin width can be set between 6 mm and 18 mm in 1 mm increments.
* The previously selected value is set as the default for the margin width. Change this
setting as desired.
* If you do not want to change the current margin width, go to the next step.
5. Select the margin position that you want by touching either the “LEFT MARG.” or “TOP
MARGIN” key. The touch panel will return to the basic screen.
6. To change the settings for the front and back margins, touch the “CHANGE #” key and go
to the next step.
Otherwise, touch the “F&B MARGIN” key. The touch panel will return to the basic screen.
* The previously selected values are set as the default for the front and back margins.
Change these settings as desired.
5-2
E_Sec5_Kinou.PM6 10/16/00, 7:13 3