1) main body, 1) main body -2 – TA Triumph-Adler DC 2062 User Manual
Page 15
Section 2 NAMES OF PARTS
2A080030A
KM-6230 (KME)
/ 131
(1) Main body
1
Front cover
2
Operation panel
3
Original size indicator lines
(When setting an original on the platen, align it with the appropriate
lines.)
4
Platen
5
Cover on the right side of the operation panel
(Open this cover when adding toner.)
6
Original tray
(Depending upon the country or region where you purchased your
copier, this part may not be included.)
7
Right upper cover
(Open this cover if paper misfeeds in the paper feed section.)
8
Right lower cover
(Open this cover if paper misfeeds in the paper feed section.)
9
Front Deck
(Holds up to 3,000 sheets of standard [75 g/m
2
or 80 g/m
2
] paper.)
0
Drawer 1
(Holds up to 500 sheets of standard [75 g/m
2
or 80 g/m
2
] paper.)
!
Drawer 2
(Holds up to 500 sheets of standard [75 g/m
2
or 80 g/m
2
] paper.)
@
Paper width guides
#
Paper length guide
$
Stack bypass tray
(Load paper here when copying onto small-size or special paper.)
%
Support extension
^
Insert guides
&
Paper feed section knob
(Turn this knob to remove paper that has been misfed in the paper
conveyor section.)
*
Paper conveyor section
(
Paper conveyor section release lever
(Operate this lever if paper misfeeds in the paper conveyor section.)
)
Fixing unit
⁄
Fixing unit knob
(Turn this knob to remove paper that has been misfed in the fixing
unit.)
¤
Total counters
(The number displayed on the upper line indicates the number of origi-
nals that have been scanned for copying. The bottom line indicates
the number of copies made.)
‹
Instruction handbook box
(Keep the instruction handbook here.)
›
Transport handles
(Use these handles when moving this machine. There are a total of
four transport handles in all.)
fi
Paper ejection cover
(Open this cover if paper misfeeds in the fixing unit or ejection sec-
tion.)
fl
Main switch
(Turn this switch ON ( | ) before copying.)
‡
Waste toner tank cover
(Open this cover when replacing the waste toner tank.)
Waste toner tank
●
DF (Document Feeder)
(Automatically feeds and scans each original, one by one, for copying.)
·
Original table
(Set the originals that you want to copy on this table.)
‚
Original insert guides
(Adjust these guides to match the width of the originals set in the DF.)
Œ
Original set indicator
(Indicates the status of the originals in the DF.)
Lights green: The originals are set properly. Press the Start key to start
copying.
Blinks green: The originals are not set properly. Reset the originals in
the DF.
Blinks red: An original has been misfed. See page 10-11 and remove
the misfed originals.)
„
DF open/close handle
(Hold this handle when opening and closing the DF.)
´
Original ejection table
(Copied originals are stored here.)
‰
Original reversing cover
(Open this cover if an original misfeeds in the DF.)
ˇ
Original ejection guide
(Open this guide when copying from originals of 8-1/2" x 14" [A4] or
larger.)
●
Duplex unit
(Paper is turned over in this unit when you make two-sided copies.)
Á
Re-feeding section
¨
Duplex cover
(Open this cover if paper misfeeds in the duplex unit.)
2-2
E_Sec2_Name.PM6
10/13/00, 13:36
3