TA Triumph-Adler DC 2062 - Manual (Page 153)

Section 10 TROUBLESHOOTING
2A080030A
KM-6230 (KME)
/ 131
1. Remove all of the originals from the original table. If the original set indicator goes out,
copying can be resumed. Reset the originals.
* If the originals are difficult to remove, or if the original set indicator continues to blink
red even after the originals are removed, go to the next step.
2. Remove all of the originals that have been ejected onto the original ejection table.
3. Open the original reversing cover.
* When opening the original reversing cover, hold the cover by the center lever.
4. Remove any misfed originals without tearing them.
5. If you cannot remove the originals easily, open the reversing unit and remove them
from there.
6. If you still cannot remove the originals easily, turn the original misfed release dial to
convey them to the position where they can be easily removed.
7. Once you have removed the misfed originals, close the reversing unit securely.
8. Close the original reversing cover. (Press down on the center lever to close it
securely.)
6 6 6 6 6 Misfeed in the optional Finisher
● Misfeed in the coupling section
If “MISFEED IN FINISHER. REMOVE PAPER.” and the misfeed location indicator shown
in the illustration appear on the touch panel, paper has misfed in the coupling section
between the Finisher and the copier.
10-12