TA Triumph-Adler DC 2062 - Manual (Page 145)

Section 10 TROUBLESHOOTING
2A080030A
KM-6230 (KME)
/ 131
3. If paper misfeeds
If a paper misfeed occurs, copying will stop, a message informing you of the misfeed will be displayed on the touch panel, and the location of the
misfeed will be displayed as well. Leave the main switch turned ON ( | ) and refer to “(3) Removal procedures” in order to remove the misfed paper.
(1) Misfeed location indicators
1 Misfeed in the paper feed section (page 10-5)
2 Misfeed in the paper conveyor section (page 10-7)
3 Misfeed in the fixing unit or ejection section (page 10-8)
4 Misfeed in the duplex unit (page 10-10)
5 Misfeed in the DF (page 10-11)
6 Misfeed in the optional Finisher (page 10-12)
7 Misfeed in the optional Side Deck (page 10-16)
The procedure to remove misfed paper can
be displayed on the touch panel by touching
the “?” key.
(2) Cautions
WARNING
High voltage is present in the charger section. Take sufficient care when working in this
area, as there is a danger of electrical shock.
CAUTION
The copier's fixing unit is extremely hot. Take sufficient care when working in this area,
as there is a danger of getting burned.
* Do not reuse misfed paper.
* If paper gets torn during removal, be sure to remove any loose scraps from inside the copier or they could cause
further misfeeds later on.
* After the misfed paper is removed, warm-up will begin, the misfeed message will disappear, and the copier will
return to the same settings as before the misfeed.
* Even if a misfeed occurs in the optional Finisher, that copy will be made again so it is not necessary to set any
misfed copies into the Sort or Non-sort trays.
10-4