Yaskawa MP920 Communications Module - Manual (Page 248)

A.2 RECEIVE MESSAGE Function (MSG-RCV)
A-19
A
A.2.4 Inputs
„ EXECUTE (RECEIVE MESSAGE EXECUTION Command)
When EXECUTE turns ON, the message is received. This command must be remained ON
until COMPLETE (Processing Completed) or ERROR (Error Occurred) turns ON.
„ ABORT (RECEIVE MESSAGE ABORT Command)
The ABORT command aborts message reception. This takes precedence over EXECUTE
(RECEIVE MESSAGE EXECUTION command).
„ DEV-TYP (Communications Device Type)
DEV-TYP specifies the communications device type.
„ PRO-TYP (Communications Protocol)
PRO-TYP specifies the communications protocol.
When transmitting messages with the MELSEC or OMRON protocol, specify MEMOBUS
protocol (=1). Protocol is converted by the communications device (217IF or 218IF).
• MEMOBUS: Setting = 1
• No-protocol 1: Setting = 2 (Data is sent or received in word units without using a proto-
col.)
• No-protocol 2: Setting = 3 (Data is sent or received in byte units without using a proto-
col.)
Note: For no-protocol transmissions, no response is received from the
sender.
„ CIR-NO (Line No.)
CIR-NO specifies the line number.
Device Type Code
215IF 1
217IF 5
218IF 6
Serial 8
SVB-01 11
Device Line No.
215IF 1 to 8
217IF 1 to 24
218IF 1 to 8
Serial 1 or 2