SMA SI 3324 Installation - Manual (Page 29)

SMA Technologie AG Installation
Installation Guide SI3324/4248-14:SE2406 Page 29
4.2 Mounting the Sunny Island 3324/4248
The following section describes the installation of the Sunny Island 3324/4248 in
detail. Keep to the order of operations suggested here:
1. Angle bracket on the bottom of the housing
2. Wall bracket
4.2.1 Angle bracket on the underside
The angle bracket on the underside of the Sunny Island 3324/4248 is mounted
backwards on delivery to avoid damage during transport. The angle bracket is used
to fasten the inverter to the wall bracket (see section 4.2.2 "Wall Bracket"
(Page 30)).
Before installing the inverter, you must first unscrew this angle bracket and then rotate
it so that the flange points downwards when the Sunny Island 3324/4248 hangs
vertically on the wall. The angle bracket can now be again screwed to the underside
of the Sunny Island 3324/4248, at the side of the the inverter that lies against the
wall (see figure below).
Underside view Side view
Wall
Angle bracket
mounted with
flange pointing
downwards