SMA SI 3324 Installation - Manual (Page 23)

SMA Technologie AG Installation
Installation Guide SI3324/4248-14:SE2406 Page 23
4 Installation
Please take note of the required installation conditions specified in section 4.1
"Preparation" (Page 23) before mounting, installing and commissioning the Sunny
Island 3324/4248.
4.1 Preparation
4.1.1 Lifting/Moving
4.1.2 Unpacking
Before installing the Sunny Island 3324/4248 make sure that all parts are included
in the delivery.
• Carefully check the packaging and the Sunny Island 3324/4248 for any signs of
damage. Please note that the housing cover is delivered unmounted. Carefully
separately remove the cover and the inverter from the packaging and do not
install the cover until the inverter is properly mounted and installed, as described
in section 6 "Removing the Cover" (Page 55).
• Ensure that all parts are included in the delivery (see section 2.4 "Scope of
Delivery" (Page 15)).
• Enter the type and serial number of the inverter into the "Guarantee and
Warranty Conditions" form.
• Keep the documents in a location where they will be easy to find later.
If something is missing or the Sunny Island 3324/4248 has been damaged during
shipment, contact SMA Technologie AG immediately. Information is provided in
section 20 "Contact" (Page 151) of this installation manual.
The Sunny Island 3324/4248 weighs 39 kg. Ensure that at least
two people are available for installing the inverter. Always wear
personal protective equipment (protective clothing, gloves, safety
boots) to avoid the danger of injuries.
Keep the packaging in case you need to return the battery inverter or its
accessories.