17 menu structure and parameter lists, 1 menu structure, Menu structure and parameter lists – SMA SI 3324 Installation User Manual
Page 130: Menu structure

Menu Structure and Parameter Lists
SMA
Technologie AG
Page 130
SI3324/4248-14:SE2406
Installation Guide
17 Menu Structure and Parameter Lists
17.1 Menu Structure
The menu structure is divided into two levels:
• User Level
• Installer Level
The menus allowing system parameters to be changed can only be reached after
entering the installer password (see section 8.3 "Password Entry" (Page 69)). Menus
protected in this manner are shown with a grey background in the following figure
(Installer Level). Menus shown with a white background are on the User Level and
can be accessed without a password. These menu parameters are used to monitor
and control the Sunny Island 3324/4248 in normal daily operation.
The main menu structure is divided into four different groups, each of which having
two subsequent submenus.
1.
Meters: The "10-Meters" main menu has the following submenus: Sunny Island
3324/4248 measurements ("11-Inverter Meters"), battery measurements ("12-
Battery Meters") and generator measurements ("13-Generator Meters").
Individual measurement values can be seen in the next two menu levels.
2.
Settings: Under the main menu "20-Settings" are four different submenus
allowing various system parameters to be viewed and changed. This affects
password entry ("21-Password Settings") and all system parameters relating to
the Sunny Island 3324/4248 ("22-Inverter Settings"), the batteries ("23-Battery
Settings") and the generator ("24-Generator Settings").
3.
Diagnose: Under the main menu "30-Diagnose" are two different submenus
allowing various diagnostic parameters to be viewed. These are system data
("31-System Information"), and fault messages ("32-Error Information").
4.
Operation: The main menu "40-Operation" allows viewing and changing of
the operating parameters (e.g. "40-8 SunnyBoys").
Please consult section 7.2 "Changing Parameters" (Page 58) for information
describing how to set the individual parameters.
Configuration and changes to system parameters may only be
performed by suitably qualified personnel (electricians).