HEIDENHAIN TNC 320 (34055x-06) - Manual (Page 72)

Introduction
2.4 Status displays
2
72
TNC 320 | User's Manual HEIDENHAIN Conversational Programming | 5/2013
Program section repeat/Subprograms (LBL tab)
Soft key Meaning
No direct
selection
possible Active program section repeats with block
number, label number, and number of
programmed repeats/repeats yet to be run
Active subprogram numbers with block number
in which the subprogram was called and the
label number that was called
Information on standard cycles (CYC tab)
Soft key Meaning
No direct
selection
possible Active machining cycle
Active values of Cycle 32 Tolerance