HEIDENHAIN TNC 320 (34055x-06) - Manual (Page 146)

Programming: Tools
5.2 Tool data
5
146
TNC 320 | User's Manual HEIDENHAIN Conversational Programming | 5/2013
Abbr. Inputs Dialog
TYPE
Tool type: Press the SELECT TYPE (3rd soft-key row);
the TNC superimposes a window where you can select
the type of tool you want. You can assign tool types
to specify the display filter settings such that only the
selected type is visible in the table
Tool type?
DOC
Comment on tool (up to 32 characters)
Tool comment?
PLC
Information on this tool that is to be sent to the PLC
PLC status?
PTYP Tool type for evaluation in the pocket table Tool type for pocket table?
NMAX Limit the spindle speed for this tool. The programmed
value is monitored (error message) as well as an increase
in the shaft speed via the potentiometer. Function
inactive: Enter
–.
Input range : 0 to +999999, if function not active: enter –
Maximum speed [rpm]?
LIFTOFF Definition of whether the TNC should retract the tool in
the direction of the positive tool axis at an NC stop in
order to avoid leaving dwell marks on the contour. If
Y
is defined, the TNC retracts the tool from the contour,
provided that this function was activated in the NC
program with M148 See "Automatically retract tool from
the contour at an NC stop: M148", page 323.
Retract tool Y/N ?
TP_NO Reference to the number of the touch probe in the touch-
probe table Number of the touch probe
T_ANGLE Point angle of the tool. Is used by the Centering cycle
(Cycle 240) in order to calculate the centering depth from
the diameter entry Point angle?
LAST_USE
Date and time that the tool was last inserted via
TOOL
CALL
Input range : Max. 16 characters, format specified
internally: Date = yyyy.mm.dd, time = hh.mm
LAST_USE