HEIDENHAIN TNC 320 (34055x-06) - Manual (Page 148)

Programming: Tools
5.2 Tool data
5
148
TNC 320 | User's Manual HEIDENHAIN Conversational Programming | 5/2013
Edit the tool table
The tool table that is active during execution of the part program is
designated TOOL.T and must be saved in the
TNC:\table directory.
Other tool tables that are to be archived or used for test runs are
given any other names with the extension T. By default, for Test
Run and Programming modes the TNC uses the "simtool.t" table,
which is also stored in the "table" directory. In the Test Run mode,
press the TOOL TABLE soft key to edit it.
To open the tool table TOOL.T:
Select any machine operating mode
Select the tool table: Press the TOOL TABLE soft
key
Set the EDIT soft key to ON
Displaying only specific tool types (filter setting)
Press the TABLE FILTER soft key (fourth soft-key row)
Select the tool type by pressing a soft key: The TNC only shows
tools of the type selected
Cancel filter: Press the previously selected tool type again or
select another tool type
The machine tool builder adapts the features of the
filter function to the requirements of your machine.
Refer to your machine manual.