HEIDENHAIN TNC 320 (34055x-06) - Manual (Page 399)

Using 3-D touch probes 12.5
12
TNC 320 | User's Manual HEIDENHAIN Conversational Programming | 5/2013
399
12.5 Using 3-D touch probes
Overview
The following touch probe cycles are available in the Manual
Operation mode:
HEIDENHAIN only gives warranty for the function of
the probing cycles if HEIDENHAIN touch probes are
used.
The TNC must be specially prepared by the machine
tool builder for the use of a 3-D touch probe. Refer to
your machine manual.
Function Soft key Page
Calibrating the effective length 407
Calibrating the effective radius 408
Measuring a basic rotation using a
line 412
Setting a datum in any axis 414
Setting a corner as datum 415
Setting a circle center as datum 417
Setting the centerline as datum 419
Touch probe system data
management See User’s
Manual for
Cycles
For more information about the touch probe table,
refer to the User’s Manual for Cycle Programming.