HEIDENHAIN TNC 320 (34055x-06) - Manual (Page 379)

Moving the machine axes 12.2
12
TNC 320 | User's Manual HEIDENHAIN Conversational Programming | 5/2013
379
12.2 Moving the machine axes
Note
Traversing with the machine axis direction buttons
can vary depending on the machine tool. Refer to
your machine manual.
Moving the axis with the machine axis direction
buttons
Select the Manual Operation mode
Press the machine axis direction button and hold it
as long as you wish the axis to move, or
Move the axis continuously: Press and hold the
machine axis direction button, then press the
machine START button
To stop the axis, press the machine STOP button.
You can move several axes at a time with these two methods. You
can change the feed rate at which the axes are traversed with the
F soft key, See "Spindle speed S, feed rate F and miscellaneous
function M", page 390.
Incremental jog positioning
With incremental jog positioning you can move a machine axis by a
preset distance.
Select the Manual Operation or El. Handwheel
mode
Shift the soft-key row
Select incremental jog positioning: Switch the
INCREMENT soft key to ON
JOG INCREMENT =
Enter the jog increment in mm, and confirm with
the ENT key
Press the machine axis direction button as often as
desired
The maximum permissible value for infeed is 10 mm.