HEIDENHAIN TNC 320 (34055x-06) - Manual (Page 467)

Displaying operating times 15.4
15
TNC 320 | User's Manual HEIDENHAIN Conversational Programming | 5/2013
467
15.3 Unit of Measurement
Application
This MOD function determines whether the coordinates are
displayed in millimeters (metric system) or inches.
To select the metric system (e.g. X = 15.789 mm), set the
Change MM/INCH function to mm. The value is displayed to 3
decimal places.
To select the inch system (e.g. X = 0.6216 inches), set the
Change MM/INCH function to inches. The value is displayed to
4 decimal places
If you would like to activate the inch display, the TNC shows the
feed rate in inch/min. In an inch program you must enter the feed
rate larger by a factor of 10.
15.4 Displaying operating times
Application
The MACHINE TIME soft key enables you to see various types of
operating times:
Operating time Meaning
Control on Operating time of the control since
being put into service
Machine on Operating time of the machine tool since
being put into service
Program run Duration of controlled operation since
being put into service
The machine tool builder can provide further
operating time displays. Refer to your machine
manual.