HEIDENHAIN TNC 320 (34055x-06) - Manual (Page 225)

Any desired program as subprogram 7.4
7
TNC 320 | User's Manual HEIDENHAIN Conversational Programming | 5/2013
225
7.4 Any desired program as subprogram
Operating sequence
If you want to program variable program calls in
connection with string parameters, use the SEL
PGM function.
1 The TNC executes the part program up to the block in which
another program is called with
CALL PGM.
2 Then the other program is run from beginning to end.
3 The TNC then resumes the first part program (i.e. the calling
program) with the block after the program call.
Programming notes
No labels are needed to call any program as a subprogram
The called program must not contain the miscellaneous
functions M2 or M30. If you have defined subprograms with
labels in the called program, you can then use M2 or M30 with
the
FN 9: IF +0 EQU +0 GOTO LBL 99 jump function to force a
jump over this program section
The called program must not contain a
CALL PGM call into the
calling program, otherwise an infinite loop will result