HEIDENHAIN TNC 320 (34055x-06) - Manual (Page 250)

Programming: Q Parameters
8.8 Additional functions
8
250
TNC 320 | User's Manual HEIDENHAIN Conversational Programming | 5/2013
Error number Text
1026 Angle reference missing
1027 No fixed cycle defined
1028 Slot width too small
1029 Pocket too small
1030 Q202 not defined
1031 Q205 not defined
1032 Q218 must be greater than Q219
1033 CYCL 210 not permitted
1034 CYCL 211 not permitted
1035 Q220 too large
1036 Q222 must be greater than Q223
1037 Q244 must be greater than 0
1038 Q245 must not equal Q246
1039 Angle range must be under 360°
1040 Q223 must be greater than Q222
1041 Q214: 0 not permitted
1042 Traverse direction not defined
1043 No datum table active
1044 Position error: center in axis 1
1045 Position error: center in axis 2
1046 Hole diameter too small
1047 Hole diameter too large
1048 Stud diameter too small
1049 Stud diameter too large
1050 Pocket too small: rework axis 1
1051 Pocket too small: rework axis 2
1052 Pocket too large: scrap axis 1
1053 Pocket too large: scrap axis 2
1054 Stud too small: scrap axis 1
1055 Stud too small: scrap axis 2
1056 Stud too large: rework axis 1
1057 Stud too large: rework axis 2
1058 TCHPROBE 425: length exceeds max
1059 TCHPROBE 425: length below min
1060 TCHPROBE 426: length exceeds max
1061 TCHPROBE 426: length below min
1062 TCHPROBE 430: diameter too large
1063 TCHPROBE 430: diameter too small
1064 No measuring axis defined
1065 Tool breakage tolerance exceeded