HEIDENHAIN TNC 320 (34055x-06) - Manual (Page 458)

Test run and program run
14.5 Program run
14
458
TNC 320 | User's Manual HEIDENHAIN Conversational Programming | 5/2013
The TNC skips all touch probe cycles in a mid-
program startup. Result parameters that are written
to from these cycles might therefore remain empty.
You may not use mid-program startup if the following
occurs after a tool change in the machining program:
The program is started in an FK sequence
The stretch filter is active
Pallet management is used
The program is started in a threading cycle
(Cycles 17, 18, 19, 206, 207 and 209) or the
subsequent program block
Touch-probe cycles 0, 1 and 3 are used before
program start
Go to the first block of the current program to start a block scan:
Enter GOTO "0"
Select mid-program startup: Press the MID-
PROGRAM STARTUP soft key
Start-up at N: Enter the block number N at which
the block scan should end
Program: Enter the name of the program
containing block N
Repetitions: If block N is located in a program
section repeat or in a subprogram that is to be run
repeatedly, enter the number of repetitions to be
calculated in the block scan
Start mid-program startup: Press the machine
START button
Contour approach (see following section)
Entering a program with the GOTO key
If you use the GOTO block number key for going into
a program, neither the TNC nor the PLC will execute
any functions that ensure a safe start.
If you use the GOTO block number key for going into
a subprogram,
the TNC will skip the end of the subprogram (
LBL
0)
the TNC will reset function M126 (Shorter-path
traverse of rotary axes)
In such cases you must always use the mid-program
startup function.