HEIDENHAIN TNC 320 (34055x-06) User Manual
Page 33
TNC 320 | User's Manual HEIDENHAIN Conversational Programming | 5/2013
33
12.7 Compensating workpiece misalignment with 3-D touch probe......................................................411
Introduction.............................................................................................................................................411
Identifying basic rotation........................................................................................................................412
Saving a basic rotation in the preset table............................................................................................ 412
Compensation of workpiece misalignment by rotating the table.......................................................... 412
Displaying a basic rotation..................................................................................................................... 413
Canceling a basic rotation......................................................................................................................413
12.8 Datum Setting with 3-D Touch Probe................................................................................................ 414
Overview................................................................................................................................................ 414
Datum setting in any axis...................................................................................................................... 414
Corner as datum.................................................................................................................................... 415
Circle center as datum...........................................................................................................................417
Setting a center line as datum...............................................................................................................419
Measuring workpieces with a 3-D touch probe.....................................................................................420
Using touch probe functions with mechanical probes or measuring dials.............................................423
12.9 Tilting the working plane (software option 1)..................................................................................424
Application, function...............................................................................................................................424
Traversing reference points in tilted axes.............................................................................................. 426
Position display in a tilted system......................................................................................................... 426
Limitations on working with the tilting function.................................................................................... 426
To activate manual tilting:...................................................................................................................... 427
Setting the current tool-axis direction as the active machining direction...............................................428
Setting the datum in a tilted coordinate system................................................................................... 429