QuickLabel Plexo! 653 - Manual (Page 94)

Service Functions
82 Plexo! 453 / Plexo! 653 User Guide
3 Copy the firmware file to the "misc" directory of the memory medium. This can be
done on a computer or via FTP on the printer.
4 Insert the prepared memory medium into the printer.
5 Press the menu button.
6 Select Service > Firmw. fr. card menu.
7 Press the Enter button.
8 If the function Firmw. fr. card is protected via a PIN, use the arrow buttons to enter
the code number and confirm with the Enter button
The names of the firmware files found on the memory medium are shown in the
display.
9
If several firmware files are found on the memory medium, select the desired file
with the up and down buttons.
10 Press the Enter button.
The selected firmware file is copied. A progress indicator is displayed while the
firmware is being copied. OK appears in the display once copying is successfully
completed.
11 Press the Enter button.
Error Messages during the Firmware Update
If an error occurs during the update, one of the following error codes is shown in the
display:
Note: If an error occurs with a firmware update, the old firmware version is no longer usable.
Restart programming in this case.
Save settings
Note: Access only possible with CF memory card inserted.
Error code Meaning
C Checksum error. /b may have been forgotten in the COPY
command or the file is defective.
H Header error. /b may have been forgotten in the COPY com-
mand or the file is defective.
E EPROM could not be cleared.
V Programming voltage is too low.
P Programming error.