Mounting the cutter tray, Mounting the cutter, Mounting the cutter tray mounting the cutter – QuickLabel Plexo! 653 User Manual
Page 73

CU4/CU6 Cutter Accessory
Plexo! 453 / Plexo! 653 User Guide
61
Mounting the Cutter Tray
1
Loosen the screws (1).
2
Place the cutter tray (2) on the screws (1) in front of the tear-off plate or the
dispense plate and slide it to the left until it stops.
3
Tighten the screws (1).
4
The length of the cutter tray (2) may be modified by moving the slide (3).
Mounting the Cutter
Note: The printer must be switched off before attaching the cutter!
In order to install the cutter, the front cover is to be removed.
1
Turn the printer off. Open the media cover.
2
Loosen the screw (2).
This manual is related to the following products: