QuickLabel Plexo! 653 - Manual (Page 101)

Plexo! 453 / Plexo! 653 User Guide 89
14
Memory cards
You can save graphics, fonts, label descriptions and database information for the
long?]term on a memory card.
Note: Always create a backup copy of the memory card in case of a malfunction.
Suitable Memory Media
External media
• Type 1 CompactFlash card up to a maximum size of 2 GB in the corresponding
card slot of the printer or in the external operating panel (cab accessory)
• PC card (PCMCIA) in the corresponding card slot of the printer
• USB flash drive up to a maximum size of 2 GB at USB master interface
Internal medium
• approx. 5 MB flash memory inside the printer (Internal Flash File System)
Installation
Slide memory card contact-side first into the matching slot as far as it will go.
The rear section of the inserted memory card still extends from the device housing so
that it can be removed by hand. Or connect USB flash drive to an USB master interface.
Note: When the memory cards are slid onto the contact pins, light physical resistance can be
felt.
• Press the menu button. Check whether the Memory card menu is shown in the
display.
If the Memory card menu is not shown in the display, it could be because:
• the card slot being used is not selected as the default card slot
• the memory card is not inserted far enough into the card slot
• the memory card is entered incorrectly
Note: Do not remove a memory medium while it is being accessed. You can configure the
printer so that access to a memory medium is indicated on the status line.
See “Status Line” on
page 25.
Formatting
If the memory medium has not been pre-formatted in a suitable way, it can be
formatted it in the following manners: