QuickLabel Plexo! 653 - Manual (Page 54)

Loading Material
42 Plexo! 453 / Plexo! 653 User Guide
Inserting Labels into the Print Mechanics
1) Unroll a label strip of approx. 1 m. Guide the label strip to the print mechanics as
shown. The broken line shows the path for inside wound labels.
2) Turn levers (1,4) counterclockwise to lift both printheads.
3) Loosen the threaded pin (5) and slide the guide ring (6) to the outermost position.
4) Guide media strip through the print mechanics as shown to the upper print roller
(2).
5) Slide the guide ring (6) against the edge of the label strip (3) and tighten the
threaded pin (5).
6) Fix the media by closing the lower printhead.
7) Tighten the label strip between the printheads and close the upper printhead.
Setting the Label Sensor
The label sensor (2) can be shifted perpendicular to the direction of paper flow for
adaptation to the label medium. The sensor unit (1) of the label sensor is marked with
a indentation in the label sensor retainer.