QuickLabel Plexo! 653 - Manual (Page 109)

Fault Correction
Plexo! 453 / Plexo! 653 User Guide 97
Error Messages and Fault Correction
Vertical white lines in the
print image Printhead is dirty Clean the printhead. See
“Cleaning the Printheads”
on page 69.
Printhead is defective
(failure of heat elements) Change the printhead.
Print image is irregular,
one side is lighter Printhead is dirty Clean the printhead. See
“Cleaning the Printheads”
on page 69.
Problem Cause Remedy
Error message Cause Remedy
ADC malfunction Hardware error Switch the printer off and
then on. If error recurs
call service.
Barcode error Invalid barcode content,
e.g. alphanumeric charac-
ters in a numerical bar-
code Correct the barcode con-
tent.
Barcode too big The barcode is too big for
the allocated area of the
label Reduce the size of the
barcode or move it.
Battery low Battery of the PC card is
flat Replace battery in the PC
card.
Buffer overflow The input buffer mem-
ory is full and the com-
puter is still transmitting
data. Use data transmission via
protocol (preferably
RTS/CTS).
Card full No more data can be
stored on the memory
card Replace card.