Connecting to the power supply – QuickLabel Plexo! 653 User Manual
Page 19
Installation
Plexo! 453 / Plexo! 653 User Guide
7
•
Power cable
•
USB cable
•
Documentation
•
Documentation on CD-ROM
Note: Please keep the original packaging in case the printer must be returned.
Attention: The device and printing materials will be damaged by moisture and wetness.
•
Set up transfer printers only in dry locations protected from splash water.
Connecting to the Power Supply
The standard available interfaces and connectors are shown in Connections.
The printer is equipped with a wide area power unit. The device can be operated with
a supply voltage of 230 V~/50 Hz or 115 V~/60 Hz without adjustment.
1) Check that the device is switched off.
2) Plug the power cable into the power connection socket (25).
3) Plug the power cable into a grounded socket.
Connecting the Label Printer via Ethernet Interface
To connect the label printer to a network jack, a patch cable with an RJ45 plug for 10
Base T or 100 Base T is required. For direct connection of the printer to the Ethernet
card of a local computer, use an appropriate crossover cable.
Note: A shielded cable must be used to connect the printer to the network.
1
Connect computer and label printer with a suitable cable.
2
Make basic settings for operation of the Ethernet interface.
3
Call up the printer website.
See “Calling up the printer website” on page 27.
4
Open the "Setup" tab on the printer website.
5
6
Click Set on the "Setup" tab
7
Enter PIN and click Confirm.
8
Set up print service if necessary.
See “Print Services Raw-IP and LPD in MS
9
Adjust Windows printer setting.
See “Adjusting Windows Printer Setting” on page 8.
Note: Do not change the settings of the "IP" and "Gateway" on the printer website, as
otherwise the connection to the printer may be lost.