Setup – QuickLabel Plexo! 653 User Manual
Page 67

Accessories
Plexo! 453 / Plexo! 653 User Guide
55
Setup
Set the following parameters of the menu Setup > Interfaces > Wireless LAN 802.11
matching to the configuration of the Access Point.
Set the remaining parameters of the menu (DHCP, IP, Mask, Gateway, Network error).
Those parameters conform to the parameters of the menu Setup > Interfaces > Ethernet.
To check the reception conditions at the installation location of the printer, in the menu
Setup > Status line the widget Wi-Fi signal strength can be activated. So the signal
strength will be shown in the printer display (5).
Setup > Interfaces > Wireless LAN 802.11
SSID
A case sensitive text string of a maxi-
mum of 32 alphanumeric characters,
used as name of the wireless LAN
Encryption
Selection of the encryption type: Off,
WEP 64Bit, WEP 128Bit, WPA-PSK
(TKIP)
Key:
WEP 64 Bit: 10 Hexadecimal.l. charac-
ters
WEP 128 Bit: 26 Hexadezimal.l. charac-
ters
WPA-PSK (TKIP): 8 up to 63.