QuickLabel Plexo! 653 - Manual (Page 39)

Configuration
Plexo! 453 / Plexo! 653 User Guide 27
Configuration via the printer website
The parameters accessible via the operating panel can also be set via the website
contained in the firmware of the printer. In addition, other parameters for the Ethernet
interface are accessible there.
You can access the printer website with a Java-capable browser (e.g. Microsoft Internet
Explorer, Netscape Navigator) via the Ethernet interface. Use of the Java applets
requires at least version 1.4.2 of Java.
Calling up the printer website
It is absolutely necessary to define a PIN in order to make settings via the printer
website. You are requested to enter this PIN whenever settings are changed via the
website. The initial setting of the PIN can be make via the operating panel of the printer
or via the printer website.
1 Start the browser.
2 Call up printer website by entering the IP address via HTTP (e.g.
http://192.168.100.208).
The “Status” tab is open on the home screen.
3
Check to see if the status “Ready” is displayed.
Description of the printer website
The printer website contains the following tabs:
• Status: general status description. See “Status tab” on page 28.
• Setup: configuration parameter settings. See “Setup tab” on page 30.
• System messages: automatic sending of messages via e-mail. See “System messages
tab” on page 32.
• Printer status line: printer status line layout. See “Printer status line tab” on page 34.
• Fonts: overview of the available fonts. See “Fonts tab” on page 34.
• Devices: list of the hardware and optional components. See “Devices tab” on page 35.