QuickLabel Plexo! 653 - Manual (Page 35)

Configuration
Plexo! 453 / Plexo! 653 User Guide 23
Interfaces
1) Press the menu button.
2) Select Setup > Interfaces.
Width ASCII dump Width of the printing area in the.
Monitor mode. test function.
See
“ASCII Dump Mode” on page 77.
With the Automatic setting, the
printout of the control sequences
arriving at the printer occurs over
the maximum printing width. You
can reduce the printing area width
down to 50 mm.
Automatic
Parameter Meaning Default
Parameter Meaning Default
Default card slot Definition of the primary card slot.
Select one of the card slots on the
back of the printer with Compact-
Flash or PC-Card or the card slot in
the external operating panel with
Ext. CompactFlash. Compact-Flash
Character set Selection of the character set table
for adaptation to the computer sys-
tem used.
Switching the character set via soft-
ware is not possible. You can access
characters not available in the
selected character set, however,
using the Unicode table.
Windows 1252
RS232 Interface parameters Baud rate and
Handshake for data transfer via the
serial RS-232 interface. 57600 RTS/CTS
IEEE 1284 Configuration of the optional par-
allel interface. See the documenta-
tion of the parallel interface.
If interface is not installed, this
option is not available.