QuickLabel Plexo! 653 - Manual (Page 14)

Introduction
2 Plexo! 453 / Plexo! 653 User Guide
• Do not use the device in an explosive atmosphere.
• Do not use the device close to high-voltage power lines.
• If the device is operated with the cover open, ensure that people‘s clothing, hair,
jewelry etc. do not come into contact with the exposed rotating parts.
• The device or parts of it, especially the printheads can become hot while printing.
Do not touch during operation, and allow to cool down before changing material
and before disassembly.
• Risk of crushing when closing the cover. Touch the cover at the outside only. Do
not reach into the swivel range of the cover.
• Perform only those actions described in this operating manual. Work going
beyond this may only be performed by trained personnel or service technicians.
• Unauthorized interference with electronic modules or their software can cause
malfunctions.
• Other unauthorized work on or modifications to the device can also endanger
operational safety.
• Always have service work done in a qualified workshop, where the personnel
have the technical knowledge and tools required to do the necessary work.
• There are various warning stickers on the device. They draw your attention to
dangers.Warning stickers must therefore not be removed, as then you and other
people cannot be aware of dangers and may be injured.
• The maximum sound pressure level LpA is less than 70 dB(A).
Warning: Danger to life and limb from power supply. Do not open the device casing.
Environment
Obsolete devices contain valuable recyclable materials that should be sent for
recycling.
• Send to suitable collection points, separately from residual waste.
The modular construction of the printer enables it to be easily disassembled into its
component parts.
• Send the parts for recycling.
The electronic circuit board of the device is equipped with a lithium battery.
• Take old batteries to collection boxes in shops or public waste disposal centers.