QuickLabel Plexo! 653 - Manual (Page 76)

CU4/CU6 Cutter Accessory
64 Plexo! 453 / Plexo! 653 User Guide
Once the cutter is mounted on the printer and is ready for operation, the printer can be
used in cut mode.
All labels in a print job will be printed without stopping and be cut as chosen in the
software: after each label, after a specific quantity of labels, or at the end of a print job.
Lubrication
To guarantee of a normal function of the cutter the cylindrical area (1) of the circular
blade (2) must be greased regularly. We recommend for lubrication an All round-High
quality Grease.
Note: Disconnect the printer from the electrical outlet!
• Hold a greased brush on the cylindrical area and turn the axle (3) with a
screwdriver for slotted head screws (slot width 7 mm). During the turning the area
is all-around greased.
Cleaning
Note: Before starting any maintenance, turn the printer OFF and disconnect the printer from
the electrical outlet!
During the normal operation of the cutter, particles of dust and paper can accumulate
inside the cutter. Remove these particles with a soft brush or a vacuum.
When cutting through the label material instead of the label gap remains of adhesive
may accumulate on the blades. If operating in backfeed mode, such remains of
adhesive may be deposited on the drive roller as well.
Therefore both, the drive roller and the cutter blades, must be cleaned often.