Format card, See “format, The dire – QuickLabel Plexo! 653 User Manual
Page 105
Memory cards
Plexo! 453 / Plexo! 653 User Guide
93
7
If the function Copy memory card is protected via a PIN, use the arrow buttons to
enter the code number and confirm with the Enter button.
The copying procedure starts. When copying larger amounts of data, the copying
procedure is carried out in several copying cycles. An increasing progress
indicator is shown in the display during a copy cycle. The Insert dest. instruction
then appears.
8
Remove original card and insert the card to be written to.
The data read from the original card is transferred to the copy card. The progress
indicator in the display shrinks during this process. If only part of the data from
the original card was read out, the Insert source instruction appears.
9
Remove copy card and insert original card again.
The next copy cycle begins.
10
Repeat the previous two steps until all data has been copied.
OK is shown in the display when the entire copying procedure is complete.
11
Press the Enter button.
If the card to be written to can no longer accept data during the copying procedure,
the Card full error message appears in the display.
Format Card
You can delete all data from a memory card with the Format card function. This
reformats the memory card. This is why you can also use the Format card function if
the Unknown card or Structural err. error message was output when using the card.
You can prevent unauthorized deleting of memory cards by using a PIN.
1
Insert a memory card.
2
Press the menu button.
3
Select Memory card > Format card with the right and left arrow buttons.
4
Press the Enter button.
A selection field with the selection No appears in the display.
5
Use the up and down buttons to select Yes.
6
Press the Enter button.
7
If the function Format card is protected via a PIN, use the arrow buttons to enter
the code number and confirm with the Enter button.
The deleting procedure starts.
8
Do not remove the card from the printer during the deleting procedure.
The memory volume of the card is shown in the display as soon as the deleting
procedure is complete.