QuickLabel Plexo! 653 - Manual (Page 78)

CU4/CU6 Cutter Accessory
66 Plexo! 453 / Plexo! 653 User Guide
3 Hang out the spring (13) on the bearing plate (15) and the linear blade (11).
Note: Attend on the washers (A, B, C) for the circular blade (2) and the linear blade (11)
when you dismount the bearing plate. The washers could get lost because of their smallness.
Caution: Always keep the linear knife with one hand (11) in its position and push its axle
slightly to the mounting plate (9) of the cutter, because the spring (6) is tense.
4 Unscrew the screws (8) and remove the bearing plate (15) sideways.
5 Take the circular blade (2) out of its bearing (5). Now you can slacken the spring
(6) of the linear blade.
If you don`t want to change the linear blade you can skip to step 9.
6 Take the spring (6) and the linear blade (11) from the mounting plate (9).
7
Insert the axle of the (new) linear blade withe the washer (B) in the bearing (10) of
the mounting plate. (The inscription of the linear blade has to point downwards.)
8 Hang the spring (6) without tense on the pins of the mounting plate (9) and the
linear blade (11).
9 Turn the linear blade (11) backwards. The spring (6) gets tense. Insert the Axle of
the (new) circular blade (2) with the washer (A) in the bearing (5) of the mounting
plate.
10 Place the washer (C) on the axle of the linear blade.
11 Hang the spring (13) without tense on the pins of the linear blade (12) and the
bearing plate (14).
12 Positioning the bearing plate (14) on the axles (2, 11). The spring (13) gets tense.