Print parameters – QuickLabel Plexo! 653 User Manual
Page 32

Configuration
20
Plexo! 453 / Plexo! 653 User Guide
Print Parameters
1) Press the menu button.
2) Select Setup > Print param.
Contrast LCD
Contrast of the LCD display from 4
to 8.
6
Time Powersave.
Time between the last operation
and the activation of Powersave
mode.
5 min.
Debug mode
Operating mode which supports
the firmware programmer when
localizing errors.
Off
Parameter
Meaning
Default
Parameter
Meaning
Default
Heat level
Heating value for compensating
for the differing thermal behavior
of printheads. Changing this value
is then especially necessary if the
printing intensity has changed
after replacing the printhead.
To adapt the printing intensity
when using different media, print
speeds or printing contents, you
should change the heat level in the
software. The settings from the
Print param. menu and the soft-
ware are added together.
0
Print speed
Basic print speed setting.
You can re?]specify the print speed
for each print job via software. The
basic setting is not changed by this.
The print speed setting also affects
the test printouts.
100 mm/s