Label profile – QuickLabel Plexo! 653 User Manual
Page 91
Test Functions
Plexo! 453 / Plexo! 653 User Guide
79
The printout of the test grid can be cancelled with the cancel button.
Label profile
The Label profile function carries out a longer label advance. It saves the values
measured by the label sensor here and then prints them out in two diagrams. The
printout is used to check label detection in conjunction with the optical properties of
the label medium. The printout occurs using the heat level and print speed specified in
the Setup > Print param. menu.
Note: The printout of the diagram occurs without taking the label gaps into consideration. This
is why endless media are most suitable for the printout.
1
Select the label sensor to be tested in the menu Setup > Print param.
2
Load the label medium to be tested into the printer.
3
Press the menu button.
4
Select Test > Label profile print menu.
5
Start the function with the Enter button.
The printer performs a longer label advance. The label sensor measures the
transparency/reflection capacity of the label material here. The message Test print
OK appears in the display once the advance is complete.
6
Insert printable medium (labels, endless paper) which extends across the entire
printing width.
7
If the printout is to occur using thermal transfer printing, insert transfer ribbon
with the maximum width.
8
Start the diagram printout with the Enter button.