QuickLabel Plexo! 653 - Manual (Page 33)

Configuration
Plexo! 453 / Plexo! 653 User Guide 21
Transfer print On for thermal transfer printing:
Sensor for monitoring the transfer
ribbon is activated.
Off for thermal direct printing:
Sensor for monitoring the transfer
ribbon is not activated.
You can overwrite the setting for
each print job via software.
On
Warn levelribbon Warning via the Ethernet interface
by way of an SNMP message or
e-mail sent when the remaining
diameter of the ribbon supply roll
undershoots the set value (32.74
mm). Off
Label sensor Method for detecting the starting
end of the label.
Gap Sensor: Detection using
changes in the transparency
between the label and label gap.
Bottom-Reflect: Detection using
reflex marks on the bottom of the
medium.
Continuos media: Synchronization
of the paper flow when using end-
less media in cutting mode.
See
“CU4/CU6 Cutter Accessory” on
page 59.
Gap Sensor
Tear-off mode Positioning the label medium for
tearing off at the tear-off plate.
On: Additional advancement of the
label medium which positions the
label gap after the last printed label
at the dispense plate.
Off: Label advance stops once the
last label has fully passed the print
line.
Off
Parameter Meaning Default