K-Patents PR-23 - Manual (Page 169)

11 Safe-Drive™ 161
10 Take a firm grip on the hand wheel and the handle
and pull out the Safe-Drive™ Retractor with the
sensor inside.
A firm hold of the tool is essential as the
combination of the tool and the sensor is noticeably
heavier than Retractor alone.
Note: To ensure the isolation valve after the
Safe-Drive tool with the sensor have been removed,
you can bolt a standard ANSI 1.5" 105 lbs blind
flange to it with 1/2" (M12) bolts and nuts.
A lock can be added to the isolation valve handle.
Warning! The sensor tip is hot and may be covered
with liquor. It is recommended to rinse the sensor
tip and the isolation valve with hot water.
11
1
2
11
Put the Safe-Drive™ Retractor with sensor onto a
table or similar surface so that the hand wheel has
space to turn.
1 Turn the wheel counterclockwise until the
trapezoidal thread is all the way inside the Outer
casing and loose from the wheel, i.e. the Outer
casing is no longer connected to the parts inside.
2 Pull the Outer casing off.
12
1
2
3
12
1 Open the latch on the Inner casing.
2 Keep sensor steady with one hand and turn the
Inner casing counterclockwise with the other hand
to unlock the Inner casing from sensor.
3 Pull off the sensor.