Guralp Systems CMG-DCM build <10,000 User Manual
Page 209
Acquisition Modules and Platinum Firmware
Building Networks
Local IP address: If the GSL-EAM has multiple network addresses, you can
limit the GDI link receiver to use only one of them by entering it in this field.
If left blank, the receiver will listen on all configured addresses.
Local port/service: The default GDI link port is 1566 but this can be
over-ridden if desired - you would want to do this if you had multiple
instances running on the same address by entering a port name or number.
Back-fill
Back-fill is the process whereby missing data are recovered. It can be disabled
if desired but, in most cases, you should leave this enabled.
Enable backfill: If selected enables the back-fill transmission.
Directory: The default directory for back-fill data.
Servers
The servers tab contains a table within which you can configure the GDI link
servers to which this receiver should listen.
For each client, you should set:
•
Peer name: Should match the server name configured in the client
(receiver) at the remote end of the link
•
Remote host: The DNS name or IP address of the GDI link server
209
Issue E - February 2014