Guralp Systems CMG-DCM build <10,000 - Manual (Page 204)

Acquisition Modules and Platinum Firmware Building Networks
To configure the transmitter, click on the link corresponding to the required
instance.
13.1.1.1 Configurable parameters in simple mode
The configurable parameters for the GDI link transmitter have four tabbed
pages in simple mode: General, Network, Backfill and Push.
General
User description: Can be changed if desired. This may be useful if you have
multiple instances. This description is seen when viewing running services
or configuring instances. It is not seen by the clients.
Subsequent instances can be enabled or disabled with a check-box but this is
absent from the page for the default instance because the default instance is
always enabled.
Network
Client name: Set to the instance name as seen by the client. A suitable
default is used if this field is left blank.
Local IP address: If the acquisition module has multiple network addresses,
it can be restricted to listen for incoming connections on only one of them by
entering its address here. If left blank, the transmitter will listen on all
available instances.
MAN-EAM-0003 204 Issue E - February 2014