Comtech EF Data SDM-2020 - Manual (Page 84)

SDM-2020 Satellite Modulator Revision 7
Front Panel Operation MN/SDM2020M.IOM
5-42
5.6.8.8 FUNCTION SELECT:UTILITY:SYSTEM
TIME: 12:00:00AM
DATE: 7/04/76
The current time and date in the modulator memory are displayed. To set the modulator
time and/or date, proceed as follows:
1 Press
2 Press [ ←] or [→] to position the flashing cursor over the parameter to be changed
3 Press [ ↑] or [↓] to change the parameter to the desired value
4 Once the parameters are displayed as desired, press to set the time and date
REMOTE BAUD RATE
9600 BPS EVEN
The current baud rate and parity selection of the modulator are displayed. To set the
modulator baud rate and/or parity, proceed as follows:
1 Press .
2 Press [ ←] or [→] to position the flashing cursor over the parameter to be changed.
3 Press [ ↑] or [↓] to change the parameter to the desired value.
4 Once the parameters are displayed as desired, press to set the baud rate and
parity. The baud rate can be set from 300 to 19200. The parity can be set to EVEN, ODD, or
NONE.
REMOTE ADDRESS
1
The current modulator address is displayed (1 to 255). To set the remote address, proceed
as follows:
1 Press .
2 Press [ ↑] or [↓] to change the parameter to the desired value.
3 Press to execute the change.
Note: Address 0 is reserved as a global address.