Comtech EF Data SDM-2020 - Manual (Page 250)

SDM-2020 Satellite Modulator Revision 7
Remote Control Operation MN/SDM2020M.IOM
Parameter
Command/
Status/
Type Response Description of Arguments Comments
DTE State
Control Command:
Response:
Status:
Response: >add/DTES_xxx'cr''lf']
>add/DTES_xxx'cr''lf'] Where: xxx = NRM (Normal Sense) or INV (Inverted
Sense)
This commands control the logic sense og the DTE
signal.
DCE State
Control Command:
Response:
Status:
Response: >add/DCES_xxx'cr''lf']
>add/DCES_xxx'cr''lf'] Where: xxx = NRM (Normal Sense) or INV (Inverted
Sense)
This commands control the logic sense og the DCE
signal.
MCP
Command
Config. Command:
Response:
>add/MCP_'cr'
TDVB_xxxx'cr'
MF_nnn.nnnn'cr'
MR_nnnn_mmm.mmmmmm'cr'
MPO_snn.n'cr'
MOP_snn.n'cr'
SE_xxx'cr'
TCP_xxx'cr'
TDP_xxxx'cr'
TDF_xxxx'cr'
ISP_xxx'cr'
SYNC_xxxx'cr'
MSR_xxx'cr'
MT_xxxx'cr'
TXPU_xxxxx'cr'
COM_xxxxxx'cr'
DTEM_xxxx’cr’
TCAA_xxxxx’cr’
RF_xxx’cr’’If’]
DVB Framing Type
Modulator Frequency
Modulator Rate
Modulator Power Offset
Modulator Output Power
Scrambler Enable (ON/OFF)
Transmit Clock Phase
Transmit Data Phase
Transmit Data Fault
Transmit 2047 Pattern Generator
Transmit Sync Select
Modulator Spectrum Rotation
Modulator Type
Transmit IF Output Power-up Configuration
Carrier Only Mode
DTE Mode Control
TX Clock Activity Action
RF output (ON/OFF)
ICS
Command
Config. Command:
Response:
>add/ICS_'cr'
TCP_xxx'cr'
TDP_xxxx'cr'
ISP_xxx'cr'
SYNC_xxxx'cr'
TDF_xxxx'cr'
TDVB_xxxx'cr'
INID_xxxxxxxxx'cr'
DTEM_xxx’cr’
TCAA_xxxxx’cr’
DTES_xxx’cr’
DCES_xxx’cr’’If’]
Transmit Clock Phase
Transmit Data Phase
Transmit 2047 Pattern Generator
Transmit Sync Select
Transmit Data Fault
DVB Framing Type
Interface Identification
DTE Mode Control
TX Clock Activity Action
DTE State Control
DCE State Control
A-33