Comtech EF Data SDM-2020 - Manual (Page 241)

SDM-2020 Satellite Modulator Revision 7
Remote Control Operation MN/SDM2020M.IOM
A.5.3 C
HANGE
S
TATUS
Parameter
Type
Command/
Status/
Response
Description of
Arguments Comments
Change
Status Command:
Response: >add/CS_x'cr''lf']
Where 'x' =
'@' = NO change since last BCS_ and BCSF_ polls.
'A' = BCS_ response has changed since last BCS_ poll.
'B' = BCSF_ response has changed since last BCSF_ poll.
'C' = Both responses have changed since last BCS_ and
BCSF_ polls.
This command indicates that a change has or has not occurred
on either the BCS_ or the BCSF_ response since the last
BCS_ or BCSF_ poll.
A.5.4 U
TILITY
S
YSTEM
S
TATUS
Parameter
Type
Command/
Status/
Response Description of Arguments Comments
Equipment Type Command:
Response: >add/ET_tttttttt_xxx.yyy.zzz'cr''lf']
Where:
tttttttt = Equipment type.
xxx.yyy.zzz = Software version.
This command returns the equipment type
and the software version of the addressed
device.
Monitor & Control
Firmware
Information Command:
Response: >add/MCFI_'cr'
VER_xxx.yyy.zzz'cr'
FW/nnnnnn-ddrr'cr'
mm/dd/yyyy'cr''lf']
Where:
xxx.yyy.zzz = Software version number
(0.0.0 to 999.999.999).
nnnnnn = Firmware number (0 to 999999).
dd = Firmware dash number (0 to 99).
rr = Firmware revision (-, or A to ZZ).
A-24