Comtech EF Data SDM-2020 - Manual (Page 177)

SDM-2020 Satellite Modulator Revision 7
Remote Control Operation MN/SDM2020M.IOM
A-7
Parameter
Type
Command/Status/
Response Description of Arguments Comments
Modulator
Type Command:
Response:
Status:
Response: >add/MT_xxxx'cr'lf']
>add/MT_xxxx'cr'lf']
Where: xxxx = DVB1 or DVB2.
A.2.2 B
ULK
M
ODULATOR
C
ONFIGURATION
Parameter
Type
Command
/Status/
Response Description of Arguments Comments
Bulk
Modulator
Config Command:
Response:
Status:
Response: >add/BCM_p1,p2,p3, . . . pn'cr''lf']
This command causes the modulator to be
programmed with supplied parameters. All
parameters are separated by a ',' except for
the last parameter which has the standard
command termination character ('cr').
Parameters that do not need to be changed
can be nulled (no data between commas).
Note: This is the only command that may
be issued without first invoking the remote
command ("command is part of the initialization of this
BMC_command. Status requests to not
require that the remote command be issued
at all.
Where'pn' is the last parameter returned.