Comtech EF Data SDM-2020 - Manual (Page 31)

3-1
Chapter 3. INSTALLATION
CAUTION
The equipment contains parts and assemblies sensitive to
damage by Electrostatic Discharge (ESD). Use ESD precautionary
procedures when touching, removing, or inserting PCBs.
3.1 U
NPACKING
The modulator and manual are packaged in pre-formed, reusable, cardboard cartons
containing foam spacing for maximum shipping protection.
CAUTION
Do not use any cutting tool that will extend more than 1 inch
(2.54 cm) into the container. This can cause damage to the
modulator.
To remove the modulator:
1 Cut the tape at the top of the carton indicated by OPEN THIS END
2 Remove the cardboard/foam space covering the modulator
3 Remove the modulator, manual, and power cord from the carton
4 Save the packing material for storage or reshipment purposes
5 Inspect the equipment for any possible damage incurred during shipment
6 Check the equipment against the packing list to ensure the shipment is correct
7 Refer to Section 3.2 for installation instructions